Shake well before use. The ideal conditions for impregnating are a temperature between 10 and 30 degrees Celsius and humidity protection for around 2-3 hours. The stone should not be warmed by underfloor heating or direct sunshine.
The impregnating efficacy is adequate for fissures less than 0.3 mm.
In general, one or two wet-in-wet equipment are sufficient. In the case of less absorbent surfaces, we propose diluting with Akemi Nitro-Dilution at a ratio of 1:1.
Apply the product using a brush or mop. Airless spraying equipment with low pressure (max. 1 bar over pressure) is appropriate for treating cades with the flooding (multiple-coat) method and a jet distance of 5-10 cm (condition tubes and seals must be solvent resistant). The impregnation is applied till it reaches 40-50 cm.
About 20 minutes after application, and before the impregnation dries on the surface, any excess that has been absorbed by the stone must be fully cleaned with a towel. Polished surfaces must be polished again to remove any blooming on the surface.
If the intended result is not attained or the impregnation was applied unevenly, it is possible to repeat the impregnation. The water-repellent effect appears after a few minutes, and full protection occurs after 2-3 hours.
Sufficient ventilation (approx. 2-3 days) is required when utilizing the product in food environments.
Tools can be cleaned using Akemi nitro thinner.