Brand : Generic (Imported)
100 x 16 mm (4-inch) #36 Grit Fiber Sanding Disc of Angle Grinder for Metal and Wood Smoothening, pack of 100
SKU : TI-1X-48779
MRP :
₹1035
-
1
+
Get Extra ₹16 OFF on Prepaid Orders
Delivery By: Nov 18 - Nov 20
Add to Cart
Buy Now
Easy Return
& Refund
Quality
Assurance
Trusted
Delivery
After Sales
Assistance
Buyer
Protection
Short Description
It is primarily used for aggressively grinding, smoothing welds, removing rust, and preparing both metal and wood surfaces. For safe and effective performance, it requires a shallow operating angle (10°–15°) and consistent movement.
Country of origin: China
Specification
  • Brand: Generic (Imported)
  • Weight (Approx.) : 25 gm
  • Diameter: 100 mm (4 inches), Standard size for small to medium angle grinders.
  • Bore Size (Hole): 16 mm (5/8 inch), Standard bore size to fit a typical angle grinder spindle and backing pad.
  • Backing Material: Vulcanized Fibre, Provides the necessary rigidity and strength for high-speed use.
  • Abrasive Grain: Aluminum Oxide (A/O) or Zirconia, A/O is general-purpose; Zirconia is for heavier, longer-life applications on hard metals.
  • Grit: 36
  • Max Operating Speed: Typically 15,300 RPM or 80 m/s (Recommended) 
  • Qty: Pack of 100

Description
This is a versatile, single-layer coated abrasive disc designed for high-performance stock removal, grinding, and surface preparation. It consists of abrasive grains (typically Aluminum Oxide or Zirconia) bonded with a synthetic resin to a rigid vulcanized fiber backing.

Used with a matching rubber or plastic backing pad on an angle grinder, the disc offers an aggressive cutting action with a relatively uniform finish, making it highly effective for quickly removing material, preparing surfaces, and smoothing out welds or rough wood.

Features

 :
  • Aggressive grinding
  • Vulcanized fiber backing
  • High peripheral speeds
  • 16 mm bore

Applications

 :
  • Metal Fabrication and Welding
  • Construction and Masonry
  • Automotive and Restoration
  • General Surface Conditioning

Usage

 :
I. Preparation & Safety
  • Disconnect Power: Unplug the grinder or remove the battery.
  • Safety Gear: Put on safety glasses (must-have), face shield, and gloves.
  • Secure Workpiece: Clamp the material firmly.
II. Fitting
  • Mount Backing Pad: Place the correct size (4-inch) Backing Pad onto the grinder spindle.
  • Place Disc: Center the Fiber Disc on the pad, with the abrasive side facing out.
  • Secure Nut: Tighten the retaining nut firmly with the wrench (do not overtighten).
III. Usage (Operation)
  • Start Grinder: Power on the grinder away from the workpiece and let it reach full speed.
  • Angle is Key: Hold the disc at a shallow angle (10° to 15°) to the surface for effective cutting. Do not hold it flat.
  • Use Light Pressure: Let the disc do the work; too much pressure causes heat and premature wear.
  • Keep Moving: Use continuous, overlapping strokes. Do not dwell in one spot to avoid gouging and heat buildup.
Note: The weight has been mentioned for per pc
Select attribute